IPv6 support is available in 7.7.4, but has a severe bug where the condor_starter will likely crash when attempting to connect to another computer over IPv6.
Later versions of HTCondor should remove all of these limitations.
- ENABLE_IPV6 must be specifed in your global HTCondor configuration file, not in one of you local configuration files (the ones specified with LOCAL_CONFIG_FILE or LOCAL_CONFIG_DIR), nor using the environment variable _CONDOR_ENABLE_IPV6. #3277
- Microsoft Windows is not supported.
- Mixed IPv4/IPv6 pools are not supported.
- Security policies cannot use IP addresses, only hostnames. (If you use NO_DNS=TRUE, the "hostnames" are reformatted IP addresses, and you can match against those.)
- You must set NETWORK_INTERFACE to a specific IPv6 address. It is not possible to use multiple IPv6 interfaces on a single computer.
- Many of these settings require a condor_restart; just a condor_reconfig is likely to be insufficient.
- You must have valid IPv6 (AAAA) DNS and reverse DNS records for the computers. (NO_DNS=TRUE removes this limitation.)
ENABLE_IPV6 = TRUE
ENABLE_IPV6 = TRUE
Specify the IPv6 interface to use. Note, do
put [square brackets] around this address.
NETWORK_INTERFACE = 2607:f388:1086:0:21b:24ff:fedf:b520
- Do a condor_restart.
If you specify
as an IP address, you must put the address, but not the port, in square brackets. You can continue to specify hostnames. For example:
CONDOR_HOST =[2607:f388:1086:0:21e:68ff:fe0f:6462] # This configures the collector to listen on the non-standard port 5332. COLLECTOR_HOST =[2607:f388:1086:0:21e:68ff:fe0f:6462]:5332
$(COLLECTOR_HOST)in your security configuration if you specify an IP address.
When using NO_DNS, IPv6 addresses are turned into hostnames by taking the IPv6 address, changing colons to dashes, and appending DEFAULT_DOMAIN_NAME. So 2607:f388:1086:0:21b:24ff:fedf:b520 becomes 2607-f388-1086-0-21b-24ff-fedf-b520.example.com (assuming DEFAULT_DOMAIN_NAME=example.com)
If your HTCondor daemons are having problems communicating, and your logs contain messages like this:
|12/06/12 09:10:59 attempt to connect to <[2607:f388:1086:0:21b:24ff:fedf:b520]:52937> failed: Address family not supported by protocol (connect errno = 97). Will keep trying for 390 total seconds (390 to go).|
The likely cause is that ENABLE_IPV6 has been set in a configuration file specified in LOCAL_CONFIG_FILE or LOCAL_CONFIG_DIR, and not in the global configuration file. The configuration must be in the global configuration file.